|The CIS type 194-LD light duty folding coffin box bollard has been developed for applications needing a more cost effective and lighter folding bollard. CIS Street Furniture were pioneers of the original heavy duty version of this product in the early 1990s. This product has been imitated by many but never bettered in use or function.
This new version will fill the void between the more expensive heavy duty version and the budget above ground folding bollards. Ground box and lid are supplied galvanised with the plain steel bollard available galvanised or galvanised and polyester powder coated. The bollard can also be provided in stainless steel to give a more contemporary look.
When not in use the bollard sits in a below ground box. With simple lift and drop movement the bollard is locked in the vertical position. Three different tops can be supplied to match other bollards from our range.
Bollard height above ground: 675mm
194-LD-GL CIS type 194 light duty folding coffin box bollard – galvanised
Options: /FT Flat top /SD Semi dome top /ST Slant top
|Type 194 is a folding coffin box design. When not in use the bollard sits in a below ground box. With simple lift and drop movement the bollard is locked in the vertical position. A range of different tops can be supplied to match other cast bollards from our range.||The 197 design of folding parking bollard is useful for the security of vehicles and parking bays. The sliding mechanism gives this bollard excellent strength without solely relying on a padlock.|
Base diameter: 90mm
Root depth: 450mm
Base diameter: 70mm
Root depth: 450mm
Click here for installation details
|For light to medium duty a 3:2:1 concrete mix should be used (sulphate resisting if necessary) assuming ‘good’ soil characteristics.
For heavy duty service the foundation design may require alteration depending on site and expected service conditions.
When the bollard is to be sited on a gradient, please ensure that installation is executed as in fig. 1. In cases where fig. 2 is the only site option available then CIS must be informed at the point of order so that an additional passageway may be factory fitted to allow water to escape from the rear (bollard cap) end of the box.
This data is suggested for non-specific applications only as individual requirements and site conditions may dictate otherwise. Please refer to our technical department for advice in debatable cases.
Due to the fold down nature of this product, vertical adjustment is not possible.
Recommended installation method for all folding bollards